4AA Battery Holder with NXT Mount

CHF 1,525.00*

Content: 1 Stück

Available. If the available stock is exceeded, no additional units of this item can be added to the cart. If you have any questions, please contact the service hotline at the bottom of this page.

Product number: MS-BBX002

Product information "4AA Battery Holder with NXT Mount"

This battery holder is designed for 4AA batteries (for use with NXTServo and MTRMX-Nx). It has NXT compatible mounting holes to integrate it into your NXT contraption easily.

Bildungsstufe:	Diploma/ Vocational/ Uni, Middle years
Fach:	Robotics/ Microcontrollers, informatics

0 of 0 reviews

Leave a review!

Share your experiences with other customers.

Login

Your email address

Your password

Display reviews in current language only.

No reviews found. Share your insights with others.

Similar Items

4 x AA Battery Holder with On/Off Switch

Make a nice portable power pack with this 4 x AA battery holder. It fits any alkaline or rechargeable AA batteries in series. There's a snap on cover and an on/off switch which can be handy when wiring to something without a switch. New! We now have 0.1" headers on ends of these cables so you can plug them into a breadboard or headers with ease! Of course, you can still always solder to them or cut the ends off. The four batteries are held in series, for a nominal output of 6V DC for alkaline (6.4V when fresh, 4V when dead), and 4.8V DC for rechargeables (5.2V when fully charged, 4.4V when discharged). Using rechargeables will make this work nicely with nearly any 5V project, with alkalines you may want to put a 1N4001 in series to drop the voltage from 6V down to 5.3V.

CHF 514.00*

Details

Coin Cell Battery Holder

This is a simple coin cell battery holder that can enclose two CR2032 batteries inside itself, and safely kept closed via two phillips head screws. Each battery holder will run batteries in series, output up to 6V, and is equipped with an On/Off slide switch and two 6" power wires (one positive and one negative) on the back.

CHF 395.00*

3x AA Battery Box with Switch and Connector

This 3x AA battery, switched battery holder come compete with a terminal connector on the end of the wires. These are perfect for connecting LEDs without the need for soldering. The batteries are fully enclosed in plastic case, which is secured in place by a small screw. The unit incorporates a small on / off switch. The leads are approximately 130mm in length and colour red and black to show the polarity of the connector.

CHF 2.00*

JST Jumper Wire and Socket

This is a simple two wire cable. Great for jumping from board to board or just about anything else. There is a 2-pin JST connector on one end, bare cable on the opposite end and it also comes with the mating connector for the JST. Features: 2-pin JST connector on one end, bare cable on the opposite end. Comes with the mating connector for the JST that you can mount on a PCB. Can be used for devising more powering options for the microbit. Contents: 1 x JST Jumper Wire and Socket Dimensions: Length: 15cm.

CHF 177.00*

6-AA Battery Holder with EV3 Mount

This battery holder is designed to hold 6 AA batteries. It has LEGO NXT/EV3 compatible mounting to integrate it into your LEGO contraption easily.

CHF 1,545.00*